The router WAN connector to the onu modem yellow LAN connector?
And your PC is connected to the LAN of the router, and you can access the router web interface admin and the PPPoE status shows connected, and the test from Tools of the router shows also successful ping to outside?
Add Networks widget to your Panel or use the default System Tray and hide the entries you don’t what to see, but at least have it there … and let me know if after that your network is working.
What other browser you tested?
What happens if you run from terminal systemctl restart NetworkManager
What is showing the command cat /etc/resolv.conf
and ip addr
Did you add the system tray back to your panel? Is the network status showing connected and the correct IP?
Your issue seems to be the opposite of this one
@bogdancovaciu
Yes i did add the widget in the panel, correct ip
systemmctl restart NetworkManger
(Showing some (tick,correct) symbols)
~ sudo cat /etc/resolv.conf 1 ✘ 7s
MADE-BY-RP-PPPOE
nameserver 8.8.8.8
~ ip addr
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
inet6 ::1/128 scope host
valid_lft forever preferred_lft forever
2: enp2s0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc fq_codel state UP group default qlen 1000
link/ether d0:27:88:51:36:af brd ff:ff:ff:ff:ff:ff
inet 192.168.0.102/24 brd 192.168.0.255 scope global dynamic noprefixroute enp2s0
valid_lft 28708sec
You used initially the PPPoE connection from your linux box i guess, but if you want to use a custom DNS you better set that in the router, or use the one provided by your ISP.
Change /etc/resolv.conf to nameserver 192.168.0.1
Restart the modem, the router and your PC just to make sure, but all should be fine.
@bogdancovaciu ihave edited it with nano text editor. Restarted pc, modem & router But still browser is showing "Google’s IP address could not be found" @tracyanne
And from Terminal you can ping too outside and sync mirrors and install packages?
Is dhcpcd and NetworkManager bot services running by any chance? Only one should … I honestly don’t know what to say. Try from a TEST user you can create, and see if the issue is there too .
Well, if you disabled IPv6 on your linux wired connection, If you added the networks widget to panel and shows connected, if you tested on a new account, if you checked if time is not off from your PC to the router … then i can only point you to Network configuration - ArchWiki and take it one by one.