Hello!
I’m new to Linux. Manjaro is my first Linux install. I’ve recently installed some video editing software (Shotcut). Once I updated pacmanager shotcut worked much better however there are still some problems.
I thought if I installed some of the optional/make dependency files for Shotcut that maybe this would resolve the problems. However, when I tried to do this I got the message ‘target cannot be found’!
I updated the kernel to the most recent edition. I then followed the advise on this video:
“10 Things to do after installing Manjaro”
Which is basically:
-
Set the fastest mirror
sudo pacman-mirrors --fasttrack
-
Update your system
sudo pacman -Syu
-
Enable AUR support
-
Enable TRIM (SSD only)
-
Reduce swappiness
-
Installing Snapd
-
Check for errors
-
Firewall Configuration
-
Remove Orphans (Unused) packages
-
Backup the system
I did not complete steps 9 nor 10, however the check for errors came back with the following:
sudo journalctl -p 3 -xb ✔
-- Journal begins at Fri 2021-02-05 21:24:18 GMT, ends at Fri 2021-03-05 02:09:>
Mar 04 23:04:34 manjaro kernel: x86/cpu: VMX (outside TXT) disabled by BIOS
Mar 04 23:04:34 manjaro kernel: sd 6:0:0:0: [sdb] No Caching mode page found
Mar 04 23:04:34 manjaro kernel: sd 6:0:0:0: [sdb] Assuming drive cache: write t>
Mar 04 23:05:37 manjaro kernel: FAT-fs (sdb): unable to read boot sector to mar>
Mar 04 23:05:59 manjaro systemd[878]: Failed to start GNOME Terminal Server.
░░ Subject: A start job for unit UNIT has failed
░░ Defined-By: systemd
░░ Support: forum manjaro
░░
░░ A start job for unit UNIT has finished with a failure.
░░
░░ The job identifier is 481 and the job result is failed.
Mar 04 23:10:27 manjaro systemd-coredump[1939]: Process 1930 (pipewire-media-) >
Stack trace of thread 1930:
#0 0x000055e029c5503b n/a (pip>
#1 0x000055e029c53a6b n/a (pip>
#2 0x00007f35abe3fdf4 n/a (lib>
#3 0x00007f35abe39aa2 n/a (lib>
#4 0x00007f35abe39ff8 n/a (lib>
#5 0x00007f35acf1fd9b n/a (lib>
#6 0x00007f35ace9b5ab pw_main_>
lines 1-23...skipping...
-- Journal begins at Fri 2021-02-05 21:24:18 GMT, ends at Fri 2021-03-05 02:09:49 GMT. --
Mar 04 23:04:34 manjaro kernel: x86/cpu: VMX (outside TXT) disabled by BIOS
Mar 04 23:04:34 manjaro kernel: sd 6:0:0:0: [sdb] No Caching mode page found
Mar 04 23:04:34 manjaro kernel: sd 6:0:0:0: [sdb] Assuming drive cache: write through
Mar 04 23:05:37 manjaro kernel: FAT-fs (sdb): unable to read boot sector to mark fs as dirty
Mar 04 23:05:59 manjaro systemd[878]: Failed to start GNOME Terminal Server.
░░ Subject: A start job for unit UNIT has failed
░░ Defined-By: systemd
░░ Support: forum manjaro
░░
░░ A start job for unit UNIT has finished with a failure.
░░
░░ The job identifier is 481 and the job result is failed.
Mar 04 23:10:27 manjaro systemd-coredump[1939]: Process 1930 (pipewire-media-) of user 1000 dumped core.
Stack trace of thread 1930:
#0 0x000055e029c5503b n/a (pipewire-media-session + 0x2003b)
#1 0x000055e029c53a6b n/a (pipewire-media-session + 0x1ea6b)
#2 0x00007f35abe3fdf4 n/a (libpipewire-module-protocol-native.so + 0x16df4)
#3 0x00007f35abe39aa2 n/a (libpipewire-module-protocol-native.so + 0x10aa2)
#4 0x00007f35abe39ff8 n/a (libpipewire-module-protocol-native.so + 0x10ff8)
#5 0x00007f35acf1fd9b n/a (libspa-support.so + 0x6d9b)
#6 0x00007f35ace9b5ab pw_main_loop_run (libpipewire-0.3.so.0 + 0x425ab)
#7 0x000055e029c417dc n/a (pipewire-media-session + 0xc7dc)
#8 0x00007f35acb5eb25 __libc_start_main (libc.so.6 + 0x27b25)
#9 0x000055e029c41c5e n/a (pipewire-media-session + 0xcc5e)
Stack trace of thread 1932:
#0 0x00007f35acc3639e epoll_wait (libc.so.6 + 0xff39e)
#1 0x00007f35acf291f1 n/a (libspa-support.so + 0x101f1)
#2 0x00007f35acf1fd04 n/a (libspa-support.so + 0x6d04)
#3 0x00007f35ace81f50 n/a (libpipewire-0.3.so.0 + 0x28f50)
#4 0x00007f35acd0d299 start_thread (libpthread.so.0 + 0x9299)
#5 0x00007f35acc36053 __clone (libc.so.6 + 0xff053)
░░ Subject: Process 1930 (pipewire-media-) dumped core
░░ Defined-By: systemd
░░ Support: forum manjaro
░░ Documentation: man:core(5)
░░
░░ Process 1930 (pipewire-media-) crashed and dumped core.
lines 1-40
-- Journal begins at Fri 2021-02-05 21:24:18 GMT, ends at Fri 2021-03-05 02:09:49 GMT. --
Mar 04 23:04:34 manjaro kernel: x86/cpu: VMX (outside TXT) disabled by BIOS
Mar 04 23:04:34 manjaro kernel: sd 6:0:0:0: [sdb] No Caching mode page found
Mar 04 23:04:34 manjaro kernel: sd 6:0:0:0: [sdb] Assuming drive cache: write through
-- Journal begins at Fri 2021-02-05 21:24:18 GMT, ends at Fri 2021-03-05 02:09:49 GMT. --
Mar 04 23:04:34 manjaro kernel: x86/cpu: VMX (outside TXT) disabled by BIOS
Mar 04 23:04:34 manjaro kernel: sd 6:0:0:0: [sdb] No Caching mode page found
Mar 04 23:04:34 manjaro kernel: sd 6:0:0:0: [sdb] Assuming drive cache: write through
Mar 04 23:05:37 manjaro kernel: FAT-fs (sdb): unable to read boot sector to mark fs as dirty
Mar 04 23:05:59 manjaro systemd[878]: Failed to start GNOME Terminal Server.
░░ Subject: A start job for unit UNIT has failed
░░ Defined-By: systemd
░░ Support: forum manjaro
░░
░░ A start job for unit UNIT has finished with a failure.
░░
░░ The job identifier is 481 and the job result is failed.
Mar 04 23:10:27 manjaro systemd-coredump[1939]: Process 1930 (pipewire-media-) of user 1000 dumped core.
Stack trace of thread 1930:
#0 0x000055e029c5503b n/a (pipewire-media-session + 0x2003b)
#1 0x000055e029c53a6b n/a (pipewire-media-session + 0x1ea6b)
#2 0x00007f35abe3fdf4 n/a (libpipewire-module-protocol-native.so + 0x16df4)
#3 0x00007f35abe39aa2 n/a (libpipewire-module-protocol-native.so + 0x10aa2)
#4 0x00007f35abe39ff8 n/a (libpipewire-module-protocol-native.so + 0x10ff8)
#5 0x00007f35acf1fd9b n/a (libspa-support.so + 0x6d9b)
#6 0x00007f35ace9b5ab pw_main_loop_run (libpipewire-0.3.so.0 + 0x425ab)
#7 0x000055e029c417dc n/a (pipewire-media-session + 0xc7dc)
#8 0x00007f35acb5eb25 __libc_start_main (libc.so.6 + 0x27b25)
#9 0x000055e029c41c5e n/a (pipewire-media-session + 0xcc5e)
Stack trace of thread 1932:
#0 0x00007f35acc3639e epoll_wait (libc.so.6 + 0xff39e)
#1 0x00007f35acf291f1 n/a (libspa-support.so + 0x101f1)
#2 0x00007f35acf1fd04 n/a (libspa-support.so + 0x6d04)
#3 0x00007f35ace81f50 n/a (libpipewire-0.3.so.0 + 0x28f50)
#4 0x00007f35acd0d299 start_thread (libpthread.so.0 + 0x9299)
#5 0x00007f35acc36053 __clone (libc.so.6 + 0xff053)
░░ Subject: Process 1930 (pipewire-media-) dumped core
░░ Defined-By: systemd
░░ Support: forum manjaro
░░ Documentation: man:core(5)
I’m assuming there are loads of errors and I’m hoping someone can advise me the best way to proceed if so!!
A strange thing happened when I changed the layout and double clicked on the home icon, it automatically opened up VLC player and started playing some Bob Marley. Another problem i had was resizing the windows when opening up shotcut or osb, i think this is working okay now.
That is all for now, please let me know if you need further info, many thanks.
d_sunny