Pinebook Pro: Stuck on Manjaro boot image

Hi there,
Got the latest Manjaro XFCE 21.10 downloaded while the Pinebook Pro was running of an SD card with Manjaro on it.
Used the Manjaro Flasher to flash image onto eMCC.
Pinebook booted ok a few times.
Now it displays the Manjaro boot logo with the spinning circle.
Pressing ESC I get the following message:

ERROR: Device ‘PARTUUID=091 …’ not found. Skipping fsck.
Mount; /new_root: can’t find PARTUUID=091…
You are now being dropped into emergency shell.
Sh: can’t access tty; job control turned off.

After a few boot attempts it may start up.
Any ideas?

@Strit would you have any suggestions for this one?

Other than try a newer image (like 21.12), no.

We had some issues with eMMC installs a couple of months back, so that might be what you ran into.

Thank you for the quick reply.
I get this

[jens@Pinebook ~]$ cat /etc/lsb-release

Does that mean I have 22.01 ?

It just means that you have updated to the 22.01 packages.

Cheers, I think we can close this threat at this point. I’ll tinker around with it and if I find something noteworthy I updated it here