Only one display detected with Wayland after boot

Support Graphics & Display
1

Hello everyone,

I have an issue with using Wayland since one of the last bigger update packs (for a few weeks)
.
Wayland just detects one of my two displays which are connected via daisy chain, the other one goes into standby mode.

In the login screen, both displays are still perfectly detected.
I’ve been using Wayland without any problems before and had to switch to X11 for now, which is kind of juddery on my device and doesn’t feel very nice.
At least, X11 recognizes both displays perfectly.

With Wayland, both displays are still recognized if I unplug the Displayport cable and plug it in again. Okay as a workaround bot not satisfying.
Does anyone know this problem or can help me to fix it?
I think, it might be caused by the nVidia driver (using a 3060Ti).

WIll be able to access my computer on saturday again to deliver logs and stuff.

Thanks in advance,
rnbob

2

Welcome to the Manjaro community @rnbob

As a new or infrequent forum user, please take some time to familiarise yourself with Forum requirements, and the many ways to use the forum to your benefit:

Update Announcements

The Update Announcements contain important information and a Known Issues and Solutions section that should generally be checked before posting a request for support.

System Information

Output of this command (formatted according to forum requirements) may be useful for those wishing to help:

inxi --filter --verbosity=8

or the short form:

inxi -zv8

Be prepared to provide more information and outputs from other commands whenever asked. It’s equally important to provide as much actionable information as possible in your first post, rather than simply indicating there is a problem.

Required reading
Resources

Regards.