No pacman feedback after interrupted update

Support
3

Hi @raycoms,

I suspect you’ll have to chroot into your installation and run a complete update again to re-sync your system.

How to chroot

  1. Ensure you’ve got a relatively new ISO or at least one with a still supported LTS kernel.

  2. Write/copy/dd the ISO to a USB thumb drive.

  3. When done, boot with the above mentioned USB thumb drive into the live environment.

  4. Once booted, open a terminal and enter the following command to enter the chroot encironment:

manjaro-chroot -a
  1. If you have more than one Linux installation, select the correct one to use from the list provided.

When done, you should now be in the chroot environment.

But, be careful, as you’re now in an actual root environment on your computer, so any changes you make will persist after a restart.

Once you are in the chroot environment, you need to update/sync again.

Full update command

pamac upgrade && pamac upgrade --aur --devel || echo -e '\033[0;91mThere was an error upgrading the system. AUR packages not upgraded.\e[0m'

This will update your system and ONLY if that was successful update any AUR packages.

a Reminder: While use of the AUR is possible, it’s neither recommended nor supported.

I recommend pamac instead of pacman, especially for newcomers as pamac was developed by Manajaro (developers) for Manjaro and just takes care of more thing than pacman. For example:

Hope this helps!