Finally I did the clean install, need some help

Support
22

I am assuming that you have installed zram-generator & created an /etc/systemd/zram-generator.conf file, as per the instructions in [HowTo] Install and configure zram using zram-generator.

However, after installation & creation of the zram-generator.conf file, did you do the steps required to enable it, as per the TL;DR instructions at GitHub - systemd/zram-generator: Systemd unit generator for zram devices?

  • Run systemctl daemon-reload to create new device units.
  • Run systemctl start /dev/zram0 (adjust the name as appropriate to match the config).
  • Call zramctl or swapon to confirm that the device has been created and is in use.

If you did not use zram-generator, please advise what method you used to set up zram.

1 Like