Dell G7 7588 freeze when booting

[cscs]

Hullo,
A quick clarification or two..

@pual

Uncomment the GRUB_GFXMODE and GRUB_GFXPAYLOAD_LINUX

@pual

# The resolution used on graphical terminal
# note that you can use only modes which your graphic card supports via VBE
# you can see them in real GRUB with the command 'videoinfo'
#GRUB_GFXMODE=auto

# Uncomment to allow the kernel use the same resolution used by grub
#GRUB_GFXPAYLOAD_LINUX=keep

These are commented.

@pual

Possible Cause

• Problem 1 The plymouth module may attempt to call the NVIDIA graphics card to display the operating system logo before the NVIDIA driver is fully initialized.
• Problem 2 The grub module may attempt to call the NVIDIA graphics card to display the grub interface before the NVIDIA driver is fully initialized.

Was this in conjunction with kms and relevant MODULES or no?
(kms nvidia nvidia_modeset nvidia_uvm nvidia_drm)

Kernel mode setting - ArchWiki

PS.
For a comprehensive ‘disable or remove plymouth’ guide see here:

[HowTo] Disable or Remove Plymouth (boot splash)

In the year 2024 many Manjaro ISOs provide and enable plymouth by default. Which is to say it is not a system-critical component. It also has a nasty habit of breaking boot under various circumstances. In those cases, or simply to avoid the bloat, you can temporarily disable plymouth, permanently disable it, or remove it entirely. First an introduction to boot options for Grub You can tempoarily edit (add, remove, or change) boot options during boot from grub if you hit ‘e’ at selection. …