Additional ARM Packages

You knew I would be headed that way next. :slight_smile:

Is this link the best place to start?

Not sure. Take a look at pacman/Tips and tricks - ArchWiki

Ah, very good, thank you @Dulbi.

@Strit can we add the Glow CLI app into the official repos? AUR version: AUR (en) - glow.

Its a nice app for rendering markdown to the terminal…

I see it builds fine from AUR.
Is it gonna be used in Sway edition by default?

9 posts were split to a new topic: New Mesa drivers

Is this in unstable?

What are you refering to.

cryptmount.

I did not push it and looking above it does not seem any one was pushing it. Seems you had a pkgbuild to build it.

How about Etcher?

https://aur.archlinux.org/packages/etcher-git
There is a AUR package that is reported to work with the PinebookPro.

As an alternative usbimager is mentioned:
https://aur.archlinux.org/packages/usbimager/

1 Like

I always forget I have etcher installed and end up using dd, but +1 for the suggestion. Would like to see it in the repos.

The Etcher AUR package seems to work on my Raspberry Pi 4 too.

When I try the etcher-git package on my Pi 400 I get this error:

make: *** No rules for generating the “webpack” target. (I’m translating it to English so some terms may not be fully accurate :slight_smile: )

Am I missing something?

I used the GUI Pacman to install Etcher from AUR. It works fine and is a pretty painless way to install stuff. Just remember to change the arch=() line in the PKGBUILD to include aarch64 for the Pi.

I used this guide to figure out how to install from AUR - how-to-install-a-package-from-aur-on-manjaro-linux.

1 Like

Hi @Pak0st
Have you used obs on arm? It seems to crash on latest stable branch.

Segmentation fault.

Anyone else tried obs on arm?

I created just a small 1080p video on the PBP with OBS (needs qt5-base && Panfrost’s gl3 flag). I have no idea how it would behave for longer video capture.

I should try with at least 3-4 minute one.

Note - I sould try again on stable (I keep living on unstable :sweat_smile:). Did you try with the PBP or some other SBC?

1 Like

Yes amlogic and PBP both throwing segmentation fault. will try with gl3 flag. Can you share the flag please.

That would be PAN_MESA_DEBUG=gl3 (usually I place it in /etc/environment )

1 Like

Thanks it works will try recording something on it later tomorrow.

I was having qt5-es packages which might be causing the segmentation fault.

Thanks.

1 Like