[Stable Update] 2022-11-02 - Kernel, Plasma 5.26.2, Plasma Mobile Gear 22.09, LibreOffice, Virtualbox 7.0.2, Systemd, Mesa

Im having the same issue, but with a desktop with 2 displays connected to my 2070 Super. When I try to enable the main monitor (check “activated”, apply), it starts activating but then the settings page refreshes and the monitor is deactivated again. If I disconnect my 2nd monitor, I can activate the main monitor. I can’t enable both of them at the same time though.

I had the exact same problem when I was using testing branch like a week ago. I tried fiddling with settings, kscreen etc to no avail. Everything started working as normal when I rolled back to stable branch.

Any suggestions how to solve this? My workflow is very dependant on having 2 displays.

1 Like

The same issue with 3 monitors.

After the update only the primary one is enabled. When I try to enable auxiliary ones I get a black screen on the primary monitor and auxiliary monitors keep showing “No Signal” message.

3 Likes

No poll this time?

Probably by accident but in that case the update status page should show an error or something like “not enough votes for useful feedback” or so.

1 Like

Update somehow killed mouse support. Tried both wired and wireless mouses but neither work. On shutdown the splash screen also complains of RAS and Bluetooth daemon problems

Everything is fine, except for the still uncorrected freeze when closing the laptop lid, at 5.24 everything is fine, at 5.25, 5.26, when the power management is set to “turn off when the lid is closed”, puts the computer into a stupor, everything freezes and does not turn off. Then it turns off only with the button. Please fix this. Booted the system from scratch, without Nvidia drivers and programs, the same problem, that is, the problem is in the shell.

00:00.0 Host bridge: Intel Corporation Broadwell-U Host Bridge -OPI (rev 09)
	Subsystem: ASUSTeK Computer Inc. Device 194d
	Flags: bus master, fast devsel, latency 0
	Capabilities: <access denied>
	Kernel driver in use: bdw_uncore

00:02.0 VGA compatible controller: Intel Corporation HD Graphics 5500 (rev 09) (prog-if 00 [VGA controller])
	Subsystem: ASUSTeK Computer Inc. Device 194d
	Flags: bus master, fast devsel, latency 0, IRQ 51
	Memory at f5000000 (64-bit, non-prefetchable) [size=16M]
	Memory at d0000000 (64-bit, prefetchable) [size=256M]
	I/O ports at f000 [size=64]
	Expansion ROM at 000c0000 [virtual] [disabled] [size=128K]
	Capabilities: <access denied>
	Kernel driver in use: i915
	Kernel modules: i915

00:03.0 Audio device: Intel Corporation Broadwell-U Audio Controller (rev 09)
	Subsystem: ASUSTeK Computer Inc. Device 194d
	Flags: bus master, fast devsel, latency 0, IRQ 52
	Memory at f7214000 (64-bit, non-prefetchable) [size=16K]
	Capabilities: <access denied>
	Kernel driver in use: snd_hda_intel
	Kernel modules: snd_hda_intel

00:14.0 USB controller: Intel Corporation Wildcat Point-LP USB xHCI Controller (rev 03) (prog-if 30 [XHCI])
	Subsystem: ASUSTeK Computer Inc. Device 201f
	Flags: bus master, medium devsel, latency 0, IRQ 46
	Memory at f7200000 (64-bit, non-prefetchable) [size=64K]
	Capabilities: <access denied>
	Kernel driver in use: xhci_hcd
	Kernel modules: xhci_pci

00:16.0 Communication controller: Intel Corporation Wildcat Point-LP MEI Controller #1 (rev 03)
	Subsystem: ASUSTeK Computer Inc. Device 194d
	Flags: bus master, fast devsel, latency 0, IRQ 47
	Memory at f721d000 (64-bit, non-prefetchable) [size=32]
	Capabilities: <access denied>
	Kernel driver in use: mei_me
	Kernel modules: mei_me

00:1b.0 Audio device: Intel Corporation Wildcat Point-LP High Definition Audio Controller (rev 03)
	Subsystem: ASUSTeK Computer Inc. Device 194d
	Flags: bus master, fast devsel, latency 32, IRQ 50
	Memory at f7210000 (64-bit, non-prefetchable) [size=16K]
	Capabilities: <access denied>
	Kernel driver in use: snd_hda_intel
	Kernel modules: snd_hda_intel

00:1c.0 PCI bridge: Intel Corporation Wildcat Point-LP PCI Express Root Port #1 (rev e3) (prog-if 00 [Normal decode])
	Subsystem: ASUSTeK Computer Inc. Device 194d
	Flags: bus master, fast devsel, latency 0, IRQ 42
	Bus: primary=00, secondary=01, subordinate=01, sec-latency=0
	I/O behind bridge: [disabled] [16-bit]
	Memory behind bridge: [disabled] [32-bit]
	Prefetchable memory behind bridge: [disabled] [64-bit]
	Capabilities: <access denied>
	Kernel driver in use: pcieport

00:1c.3 PCI bridge: Intel Corporation Wildcat Point-LP PCI Express Root Port #4 (rev e3) (prog-if 00 [Normal decode])
	Subsystem: ASUSTeK Computer Inc. Device 194d
	Flags: bus master, fast devsel, latency 0, IRQ 43
	Bus: primary=00, secondary=02, subordinate=02, sec-latency=0
	I/O behind bridge: [disabled] [16-bit]
	Memory behind bridge: f7100000-f71fffff [size=1M] [32-bit]
	Prefetchable memory behind bridge: [disabled] [64-bit]
	Capabilities: <access denied>
	Kernel driver in use: pcieport

00:1c.4 PCI bridge: Intel Corporation Wildcat Point-LP PCI Express Root Port #5 (rev e3) (prog-if 00 [Normal decode])
	Subsystem: ASUSTeK Computer Inc. Device 194d
	Flags: bus master, fast devsel, latency 0, IRQ 44
	Bus: primary=00, secondary=03, subordinate=03, sec-latency=0
	I/O behind bridge: e000-efff [size=4K] [16-bit]
	Memory behind bridge: f6000000-f70fffff [size=17M] [32-bit]
	Prefetchable memory behind bridge: e0000000-f1ffffff [size=288M] [32-bit]
	Capabilities: <access denied>
	Kernel driver in use: pcieport

00:1d.0 USB controller: Intel Corporation Wildcat Point-LP USB EHCI Controller (rev 03) (prog-if 20 [EHCI])
	Subsystem: ASUSTeK Computer Inc. Device 201f
	Flags: bus master, medium devsel, latency 0, IRQ 23
	Memory at f721b000 (32-bit, non-prefetchable) [size=1K]
	Capabilities: <access denied>
	Kernel driver in use: ehci-pci

00:1f.0 ISA bridge: Intel Corporation Wildcat Point-LP LPC Controller (rev 03)
	Subsystem: ASUSTeK Computer Inc. Device 194d
	Flags: bus master, medium devsel, latency 0
	Capabilities: <access denied>
	Kernel driver in use: lpc_ich
	Kernel modules: lpc_ich

00:1f.2 SATA controller: Intel Corporation Wildcat Point-LP SATA Controller [AHCI Mode] (rev 03) (prog-if 01 [AHCI 1.0])
	Subsystem: ASUSTeK Computer Inc. Device 194d
	Flags: bus master, 66MHz, medium devsel, latency 0, IRQ 45
	I/O ports at f0b0 [size=8]
	I/O ports at f0a0 [size=4]
	I/O ports at f090 [size=8]
	I/O ports at f080 [size=4]
	I/O ports at f060 [size=32]
	Memory at f721a000 (32-bit, non-prefetchable) [size=2K]
	Capabilities: <access denied>
	Kernel driver in use: ahci

00:1f.3 SMBus: Intel Corporation Wildcat Point-LP SMBus Controller (rev 03)
	Subsystem: ASUSTeK Computer Inc. Device 194d
	Flags: medium devsel, IRQ 18
	Memory at f7219000 (64-bit, non-prefetchable) [size=256]
	I/O ports at f040 [size=32]
	Kernel driver in use: i801_smbus
	Kernel modules: i2c_i801

00:1f.6 Signal processing controller: Intel Corporation Wildcat Point-LP Thermal Management Controller (rev 03)
	Subsystem: ASUSTeK Computer Inc. Device 194d
	Flags: bus master, fast devsel, latency 0, IRQ 18
	Memory at f7218000 (64-bit, non-prefetchable) [size=4K]
	Capabilities: <access denied>
	Kernel driver in use: intel_pch_thermal
	Kernel modules: intel_pch_thermal

02:00.0 Network controller: Intel Corporation Wireless 7260 (rev cb)
	Subsystem: Intel Corporation Dual Band Wireless-AC 7260
	Flags: bus master, fast devsel, latency 0, IRQ 53
	Memory at f7100000 (64-bit, non-prefetchable) [size=8K]
	Capabilities: <access denied>
	Kernel driver in use: iwlwifi
	Kernel modules: iwlwifi

03:00.0 3D controller: NVIDIA Corporation GF117M [GeForce 610M/710M/810M/820M / GT 620M/625M/630M/720M] (rev a1)
	Subsystem: ASUSTeK Computer Inc. GeForce 820M
	!!! Unknown header type 7f
	Memory at f6000000 (32-bit, non-prefetchable) [size=16M]
	Memory at e0000000 (64-bit, prefetchable) [size=256M]
	Memory at f0000000 (64-bit, prefetchable) [size=32M]
	I/O ports at e000 [size=128]
	Expansion ROM at f7000000 [disabled] [size=512K]
	Kernel modules: nouveau, nvidia_drm, nvidia

Moderator edit: In the future, please use proper formatting: [HowTo] Post command output and file content as formatted text

No poll? The update is fine for me.

2 Likes

Smth wrong with task switcher on KDE:

@philm You missed to paste to Poll vote.

Check again. :wink:

5 Likes

After this update I’m experiencing a small issue with KDE:

https://bugs.kde.org/show_bug.cgi?id=460310

The Konsole and Kate windows got very small and centered - I just need to resize them again, so no real issue, but anoying nevertheless…

EDIT: i found the answer: yes, you can remove it.

a second check is to boot with “acpi_backlight=video” added to the kernel commandline and then run “ls /sys/class/backlight” again, if you now additionally also have an “acpi_video0” entry then your laptop should work fine with 6.1

I have an affected “amdgpu_bl0”.
After setting “acpi_backlight=video” I get a good result now showing “acpi_video0 amdgpu_bl0

SO, do I now remove the kernel param “acpi_backlight=video” ? or leave it?

1 Like

Those who still have issues with Plasma can check this out:KDE plasma bugs after each update [Stable Update] 2022-09-12 - #104 by Aragorn

1 Like

My Terminal no longer works after update.

Just a message appears in Terminal:


Warning: Program '/bin/bash' crashed.

A quick search helps here @Kobold

https://bbs.archlinux.org/viewtopic.php?id=200471

Japanese method input via fcitx was working before update, and not after :smiley:

Strangely enough, it appears to start, but the shortcut does not switch to the Japanese input.

I’m on KDE btw.
Installed packages are: fcitx, fgxitx-mozc fcitx-qt5 fcitx-configtool

It is always better to open a fresh topic for your issue @Sarah maybe here: Support - Manjaro Linux Forum. Also state which desktop environment is used as it would be wild guessing otherwise …

Here some quick search on that issue with KDE @Sarah

https://bugs.kde.org/show_bug.cgi?id=457149

https://groups.google.com/g/fcitx-announce/c/eVDQT3tKBRE

Try to migrate to fcitx5 …

I dont see how this Topics/Links fixing my problem.

I dont use differend accounts on Manjaro KDE, i have my main account only. I also just normally start the Terminal… nothing special here (no additional app start, just the console) and the console is unusable.