It is at least a couple of weeks that I have been searching without any luck to solve a weird issue that happened during august full upgrade of Manjaro.
Everytime I connect to a host using Remmina every single command I write has the result of interpreting a simple CRLF with only a LF
a change in libssh - wait until it get’s updated - or get from the manjaro sync pool
And please - don’t post images
sudo pacman -U https://mirror.easyname.at/manjaro/pool/sync/libssh-0.11.1-1-x86_64.pkg.tar.zst
Thank you
I was getting mad
Sorry for asking, why no images ?
because they are not searchable - it takes up a lot of diskspace - it contributes heavily to the service diskusage.
and because it says so in the forum rules
1 Like
Sorry for that, no intention to break the rules
Next time should i post a link ? is it better?
1 Like
If you think you can’t describe things without pictures good enough, then yes.
Upload to an image sharing site and post the link to it here.
2 Likes
If the info is in text, as it often is, just post the text and mark it as a code, like this:
(12/24) Updating linux initcpios...
==> Building image from preset: /etc/mkinitcpio.d/linux610.preset: 'default'
==> Using default configuration file: '/etc/mkinitcpio.conf'
-> -k /boot/vmlinuz-6.10-x86_64 -g /boot/initramfs-6.10-x86_64.img
==> Starting build: '6.10.6-10-MANJARO'
1 Like