How to Install Intel 82579LM ethernet driver?

[echo26]

Unable to obtain ethernet drivers fro my Hp Elitebook 8470p:
Inxi

Network:
Device-1: Intel Centrino Advanced-N 6205 [Taylor Peak] driver: iwlwifi 
v: kernel port: 4000 bus-ID: 25:00.0 chip-ID: 8086:0085 class-ID: 0280 
IF: wlan0 state: up mac: <filter> 

lspci

00:00.0 Host bridge: Intel Corporation 3rd Gen Core processor DRAM Controller (rev 09)
00:01.0 PCI bridge: Intel Corporation Xeon E3-1200 v2/3rd Gen Core processor PCI Express Root Port (rev 09)
00:14.0 USB controller: Intel Corporation 7 Series/C210 Series Chipset Family USB xHCI Host Controller (rev 04)
00:16.0 Communication controller: Intel Corporation 7 Series/C216 Chipset Family MEI Controller #1 (rev 04)
00:16.3 Serial controller: Intel Corporation 7 Series/C210 Series Chipset Family KT Controller (rev 04)
00:1a.0 USB controller: Intel Corporation 7 Series/C216 Chipset Family USB Enhanced Host Controller #2 (rev 04)
00:1b.0 Audio device: Intel Corporation 7 Series/C216 Chipset Family High Definition Audio Controller (rev 04)
00:1c.0 PCI bridge: Intel Corporation 7 Series/C216 Chipset Family PCI Express Root Port 1 (rev c4)
00:1c.1 PCI bridge: Intel Corporation 7 Series/C210 Series Chipset Family PCI Express Root Port 2 (rev c4)
00:1c.2 PCI bridge: Intel Corporation 7 Series/C210 Series Chipset Family PCI Express Root Port 3 (rev c4)
00:1c.3 PCI bridge: Intel Corporation 7 Series/C216 Chipset Family PCI Express Root Port 4 (rev c4)
00:1d.0 USB controller: Intel Corporation 7 Series/C216 Chipset Family USB Enhanced Host Controller #1 (rev 04)
00:1f.0 ISA bridge: Intel Corporation QM77 Express Chipset LPC Controller (rev 04)
00:1f.2 SATA controller: Intel Corporation 7 Series Chipset Family 6-port SATA Controller [AHCI mode] (rev 04)
01:00.0 VGA compatible controller: Advanced Micro Devices, Inc. [AMD/ATI] Thames [Radeon HD 7550M/7570M/7650M]
01:00.1 Audio device: Advanced Micro Devices, Inc. [AMD/ATI] Turks HDMI Audio [Radeon HD 6500/6600 / 6700M Series]
24:00.0 FireWire (IEEE 1394): JMicron Technology Corp. IEEE 1394 Host Controller (rev 30)
24:00.1 System peripheral: JMicron Technology Corp. SD/MMC Host Controller (rev 30)
24:00.2 SD Host controller: JMicron Technology Corp. Standard SD Host Controller (rev 30)
25:00.0 Network controller: Intel Corporation Centrino Advanced-N 6205 [Taylor Peak] (rev 34)

I dont know specifically the hardware that is installed but according to Hp Website, device has Intel 82579LM / V.

Ip link only shows
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP mode DORMANT group default qlen 1000
link/ether  brd ff:ff:ff:ff:ff:ff

[echo26]

Solution:

• Installed e1000e driver that needed to be installed,
  https://aur.archlinux.org/packages/e1000e-dkms/

• Reinstall dkms and linux header 54 corresponds to my current kernel version

  uname -r
  sudo pacman -Syu linux-headers
  

• went into BIOS to disable Wake-on-LAN

• Re-enable LAN Controller from BIOS

• modprobe e1000e after driver installation

Some diagnostic output after it started working:

Executing ip address now gives:

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN mode DEFAULT group default qlen 1000
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
2: eth0: <NO-CARRIER,BROADCAST,MULTICAST,UP> mtu 1500 qdisc fq_codel state DOWN mode DEFAULT group default qlen 1000
link/ether  brd ff:ff:ff:ff:ff:ff
4: wlan0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP mode DORMANT group default qlen 1000
link/ether  brd ff:ff:ff:ff:ff:ff

The output of lspci now is:

00:19.0 Ethernet controller: Intel Corporation 82579LM Gigabit Network Connection (Lewisville) (rev 04)
Subsystem: Hewlett-Packard Company Device 179b
Flags: bus master, fast devsel, latency 0, IRQ 33
I/O ports at 5020 [size=32]
Capabilities: <access denied>
Kernel driver in use: e1000e
Kernel modules: e1000e